The Dry Collodion Process
Charles Alan Long
9781465652737
213 pages
Library of Alexandria
Overview
Some care is required in the preparation of this solution, in order that it may be clear and bright when finished, and not contain particles that would be deposited in its passage over the Collodion film when being used. The chief precaution to be observed is not to allow it to boil too rapidly, and not to conduct the operation over too fierce a fire; attention to this will prevent many failures, and ensure a solution in every way suited for the process. Take one ounce of the best transparent gelatine, and throw it into a pipkin in which has been previously placed one pint of distilled water; set this on a slow fire, or over a lamp, until the gelatine is completely melted; then weigh out half ounce of pure citric acid and dissolve it in two ounces of distilled water; add this to the solution of gelatine, stirring it during the addition with a glass rod. The solution in the pipkin is now to be gently boiled for about half an hour: remove it from the fire, and add sufficient distilled water to make up the bulk of liquid to one pint. When quite cold, the liquid in the pipkin is to be filtered through two thicknesses of pure white blotting paper into a bottle perfectly dry and clean. We now add to every pint of filtered preservative solution, two ounces of alcohol of the specific gravity of 840. The solution thus prepared is ready for use, and should be of a pale amber colour, without any signs of insoluble particles floating in it; should any appear after it has been prepared for some days, a second filtration will remove them, and render the liquid again bright and clear. It will be found better to prepare this solution only in the quantity indicated above, unless the consumption be large, for, although it will keep good for a month or more, my experience points to the fact, that the most successful results follow the use of Preservative Solution freshly prepared.
